- Compaction of granular, mixed and cohesive soils in a confined area.
- Ideal for sites where noise and emissions are a concern.
- Ideal for sites where noise and emissions are a concern.
- Proper footwear and hearing protection are a must.
- Wear a dust mask if working in a confined area.
- Do not operate on uneven surfaces or when the machine is on an angle.
- Make sure the switch is in the off position before plugging the unit into an electrical socket.
- Use only a 50' 12 Ga. extension cord.
- Wear a dust mask if working in a confined area.
- Do not operate on uneven surfaces or when the machine is on an angle.
- Make sure the switch is in the off position before plugging the unit into an electrical socket.
- Use only a 50' 12 Ga. extension cord.
- Shoe Width: 10" (250 mm).
- Weight: 123 lbs. (56 kg).
- Compaction Depth: 18" (450 mm).
- Motor: 115 V/ 15 A.
- Weight: 123 lbs. (56 kg).
- Compaction Depth: 18" (450 mm).
- Motor: 115 V/ 15 A.
- Turn the switch off.
- Plug the extension cord into a circuit that can deliver 15 A (115 V).
- Plug unit into extension cord.
- Hold unit firmly and turn the switch on.
- Guide the rammer with the handle.
- Allow machine to pull itself forward.
- Turn the switch off when the job is completed.
- For full operating instructions, please refer to the operators manual.
- Plug the extension cord into a circuit that can deliver 15 A (115 V).
- Plug unit into extension cord.
- Hold unit firmly and turn the switch on.
- Guide the rammer with the handle.
- Allow machine to pull itself forward.
- Turn the switch off when the job is completed.
- For full operating instructions, please refer to the operators manual.
Unit will not start
- Make sure the extension cord is not damaged and is connected correctly.
- Ensure that a fuse or circuit breaker has not been tripped - Check the "ON/OFF" switch, make sure you are moving it to the ON position.
- Make sure the extension cord is not damaged and is connected correctly.
- Ensure that a fuse or circuit breaker has not been tripped - Check the "ON/OFF" switch, make sure you are moving it to the ON position.
