- For the compaction of granular and mixed materials with some cohesive content.
- For hot and cold asphalt in confined areas (i.e.. parking lots, next to structures, etc.).
- For hot and cold asphalt in confined areas (i.e.. parking lots, next to structures, etc.).
- Use only in well ventilated areas.
- Ensure that proper clothing is worn when operating this unit (i.e. safety shoes, hearing protection).
- Do not operate on uneven surfaces or grades.
- Make sure that unit stays upright at all times.
- Do not refuel while the engine is running or hot.
- Ensure that proper clothing is worn when operating this unit (i.e. safety shoes, hearing protection).
- Do not operate on uneven surfaces or grades.
- Make sure that unit stays upright at all times.
- Do not refuel while the engine is running or hot.
- Width of Plate: 14" (360mm).
- Weight: 140 lbs. (64 kg).
- Compaction Depth: up to 12 " (300 mm).
- Fuel: regular gas.
- Weight: 140 lbs. (64 kg).
- Compaction Depth: up to 12 " (300 mm).
- Fuel: regular gas.
- Turn the "ON/OFF" switch to the "ON" position.
- Close the choke (if the engine is cold).
- Open the throttle to approximately 1/2 way.
- Pull the starter rope until the unit starts.
- Once the motor starts, open the choke.
- Once you're ready to compact, move the throttle to the wide open position.
- Allow unit to pull itself forward.
- When finished, idle machine down.
- Turn the switch to the "OFF" position to stop the engine.
- For full operating instructions, please refer to the operators manual.
- Close the choke (if the engine is cold).
- Open the throttle to approximately 1/2 way.
- Pull the starter rope until the unit starts.
- Once the motor starts, open the choke.
- Once you're ready to compact, move the throttle to the wide open position.
- Allow unit to pull itself forward.
- When finished, idle machine down.
- Turn the switch to the "OFF" position to stop the engine.
- For full operating instructions, please refer to the operators manual.
Unit will not start
- Check fuel level.
- Ensure all starting procedures have been followed (i.e. choke on, switch on, etc.).
- Unit may be flooded, let sit for 10 minutes then try starting again.
- Check the oil level.
- Check fuel level.
- Ensure all starting procedures have been followed (i.e. choke on, switch on, etc.).
- Unit may be flooded, let sit for 10 minutes then try starting again.
- Check the oil level.
