- Used to clean, texture or roughen concrete or asphalt surfaces.
- Ideal for parking deck repairs, coatings removal, road repair, factory floor preparation or cleaning, repairing mall floors, etc., etc.
- The addition of an exhaust purifier also makes this scarified ideally suited for areas where emissions are of concern.
- Ideal for parking deck repairs, coatings removal, road repair, factory floor preparation or cleaning, repairing mall floors, etc., etc.
- The addition of an exhaust purifier also makes this scarified ideally suited for areas where emissions are of concern.
- Always wear the proper safety clothing while operating this machine (dust mask, safety shoes, hearing protection, safety glasses).
- Ensure that all the guards and safety devices are in place and are in working order.
- Make sure that the drum (cage) is installed properly.
- Never refuel engine while it is running or when it is hot.
- Make sure engine is off and the key is out of the machine before changing or checking drum.
- Ensure that all the guards and safety devices are in place and are in working order.
- Make sure that the drum (cage) is installed properly.
- Never refuel engine while it is running or when it is hot.
- Make sure engine is off and the key is out of the machine before changing or checking drum.
- Weight: 550 lbs. (250 kg).
- Cutting Width: 8.5" (250 mm).
- Engine: 20 HP Gas Powered with exhaust scrubber.
- Depth/Pass: 0" - 3/16" (0 mm - 5mm).
- Fuel: regular gas.
- Cutting Width: 8.5" (250 mm).
- Engine: 20 HP Gas Powered with exhaust scrubber.
- Depth/Pass: 0" - 3/16" (0 mm - 5mm).
- Fuel: regular gas.
Detailed operation instructions will be given at the time of rental.
- Install the proper drum on the machine for the job.
- Hook up dust control hoses if needed.
- Start machine and perform the job at hand.
- For full operating instructions, please refer to the operators manual.
- Install the proper drum on the machine for the job.
- Hook up dust control hoses if needed.
- Start machine and perform the job at hand.
- For full operating instructions, please refer to the operators manual.
Unit will not start
- Check fuel level.
- Ensure all starting procedures have been followed (i.e. choke on, switch on, etc.).
- Unit may be flooded, let sit for 10 minutes then try starting again.
- Check the oil level.
- Check fuel level.
- Ensure all starting procedures have been followed (i.e. choke on, switch on, etc.).
- Unit may be flooded, let sit for 10 minutes then try starting again.
- Check the oil level.
