- For cutting, welding, brazing and heating metal.
- Excellent for cutting in confined or remote areas where flexibility and quick set up is critical.
- Excellent for cutting in confined or remote areas where flexibility and quick set up is critical.
- Read the owners manual prior to use.
- Use in accordance with local and provincial regulations.
- Always keep combustibles and vapors away from torch.
- Have a fire extinguisher handy at all times.
- Allows wear protective clothing, gloves, eyewear.
- Always stand to one side of regulator and open cylinder valve slowly.
- Do not use or compress acetylene at pressures higher than 15 PSI.
- Never allow oil or grease to come in contact with oxygen.
- Never use oxygen as a substitute for compressed air.
- Follow the proper handling and storage of compressed gases at all times.
- Use in accordance with local and provincial regulations.
- Always keep combustibles and vapors away from torch.
- Have a fire extinguisher handy at all times.
- Allows wear protective clothing, gloves, eyewear.
- Always stand to one side of regulator and open cylinder valve slowly.
- Do not use or compress acetylene at pressures higher than 15 PSI.
- Never allow oil or grease to come in contact with oxygen.
- Never use oxygen as a substitute for compressed air.
- Follow the proper handling and storage of compressed gases at all times.
- Capable of cutting up to 1" thick.
- Larger capacity tips available to allow cutting up to 6".
- Welding up to 1/4" thick.
- 25' Hose.
- Larger capacity tips available to allow cutting up to 6".
- Welding up to 1/4" thick.
- 25' Hose.
- Familiarize yourself with manufacturer's safety requirements and operating instructions prior to use.
- Blow out cylinder valves before attaching regulators.
- Back off adjusting screws on regulators before opening cylinder valves.
- Stand to side of regulator and open cylinder valve slowly.
- Purge the oxygen and fuel gas lines separately before lighting torch.
- Adjust regulators to normal operating pressures and check for leaks with a leak test solution.
- During cutting a normal range is 3-5 PSI acetylene and 25-30 PSI oxygen, but will vary on thickness of material to be cut.
- Light the acetylene before opening the oxygen valve on the torch.
- Turn the valve slowly until the smoke subsides and flames jumps away from tip slightly.
- Slowly open the oxygen valve until a brilliant neutral flame is reached.
- To shut off the torch, turn off the oxygen valve on the torch first. Then acetylene.
- Close the cylinder valves, drain t - For full operating instructions, please refer to the operators manual.
- Blow out cylinder valves before attaching regulators.
- Back off adjusting screws on regulators before opening cylinder valves.
- Stand to side of regulator and open cylinder valve slowly.
- Purge the oxygen and fuel gas lines separately before lighting torch.
- Adjust regulators to normal operating pressures and check for leaks with a leak test solution.
- During cutting a normal range is 3-5 PSI acetylene and 25-30 PSI oxygen, but will vary on thickness of material to be cut.
- Light the acetylene before opening the oxygen valve on the torch.
- Turn the valve slowly until the smoke subsides and flames jumps away from tip slightly.
- Slowly open the oxygen valve until a brilliant neutral flame is reached.
- To shut off the torch, turn off the oxygen valve on the torch first. Then acetylene.
- Close the cylinder valves, drain t - For full operating instructions, please refer to the operators manual.
Cannot get a neutral flame.
- Check pressure settings on regulators.
- Turn off torch and inspect the tip for blockages.
- Check pressure settings on regulators.
- Turn off torch and inspect the tip for blockages.
