- Used as a platform by having two beams at the top of your scaffolding supported by U-Heads.
- These beams support 3/4" plywood nailed to the beam to create a working platform.
- Used as shoring for supporting heavy materials.
- Available in lengths up to 18'.
- These beams support 3/4" plywood nailed to the beam to create a working platform.
- Used as shoring for supporting heavy materials.
- Available in lengths up to 18'.
- Be sure beams are secured into place.
- Ensure that there is at least 1' of overhang from your scaffolding tower.
- Make sure all the components you are going to use are in good condition, do not use any damaged, dirty, bent or broken pieces.
- Make sure your beams are level.
- Wear gloves, hard hat and safety boots when erecting the scaffolding.
- Ensure that there is at least 1' of overhang from your scaffolding tower.
- Make sure all the components you are going to use are in good condition, do not use any damaged, dirty, bent or broken pieces.
- Make sure your beams are level.
- Wear gloves, hard hat and safety boots when erecting the scaffolding.
- Width of 6 1/2".
- Available in a variety of lengths.
- All aluminum construction with wood strip on top of beam for securing plywood to.
- Available in a variety of lengths.
- All aluminum construction with wood strip on top of beam for securing plywood to.
- Have at least two people to set up the scaffolding.
- Install the U-Heads into the top of the scaffolding tower.
- Insert the beam into the U-Heads and nail plywood onto the wood strip on the beam.
- For full operating instructions, please refer to the operators manual.
- Install the U-Heads into the top of the scaffolding tower.
- Insert the beam into the U-Heads and nail plywood onto the wood strip on the beam.
- For full operating instructions, please refer to the operators manual.
- If the components do not connect, check for possible defects such as dirt, bends, weak welds, crushed ends, etc.
