- To drain waterbeds.
- Transfer of water over level surface.
- Transfer of water over level surface.
- Do not handle the pump with wet hands.
- Ensure the power source conforms to the requirements of the pump.
- Keep children a safe distance from the work area.
- Do not insert any objects into the motor.
- Do not run the pump dry.
- Do not pump flammable fluids.
- Ensure the power source conforms to the requirements of the pump.
- Keep children a safe distance from the work area.
- Do not insert any objects into the motor.
- Do not run the pump dry.
- Do not pump flammable fluids.
- Volts are 115 volts.
- Dimensions are 3"x6".
- 300 Gallons an hour with no hose attached.
- Dimensions are 3"x6".
- 300 Gallons an hour with no hose attached.
- Attach the intake and outtake hoses.
- Prime intake hose with water while attached to the pump.
- Place the intake hose inside the waterbed or attach it to fitting supplied with bed.
- Place the outtake hose in an area where the drainage of water is permissible.
- Plug the pump in and let it run until all the water has been pumped from the waterbed.
- Once all the water has been pumped unplug the pump and detach both the hoses.
- Unit will not pump if hose is elevated.
- Do not use pump for fuels or oils.
- For full operating instructions, please refer to the operators manual.
- Prime intake hose with water while attached to the pump.
- Place the intake hose inside the waterbed or attach it to fitting supplied with bed.
- Place the outtake hose in an area where the drainage of water is permissible.
- Plug the pump in and let it run until all the water has been pumped from the waterbed.
- Once all the water has been pumped unplug the pump and detach both the hoses.
- Unit will not pump if hose is elevated.
- Do not use pump for fuels or oils.
- For full operating instructions, please refer to the operators manual.
the pump will not run.
- No power is being supplied to the pump.
- The impeller is jammed.
- The motor has overheated.
- Elevate the waterbed mattress so water is always at drain hole.
- Ensure inner flaps of waterbed are not covering drain hole.
- No power is being supplied to the pump.
- The impeller is jammed.
- The motor has overheated.
- Elevate the waterbed mattress so water is always at drain hole.
- Ensure inner flaps of waterbed are not covering drain hole.
