Hedge Trimmer, 30″ Gas

- Used to trim hedges & bushes.
- Gas powered, eliminating the need for extension cords.
- Heavy duty, able to handle larger branches.

- Wear gloves, hearing & eye protection.
- Ensure that you have good footing while operating this tool.
- While the trimmer is in operation, keep both hands on the tool at all times.

- 30" cutting blade.
- 2 Stroke gas engine.

- Place the unit on the ground & remove blade cover if applicable.
- Press the throttle switch in slightly while turning the on/off switch fully to the on position.
- Continue to hold the on/off switch while letting go of the throttle.
- This sets the throttle at the halfway point for easier starting.
- Pull the cord until the engine turns over.
- Turn the choke to the open (off) position.
- Pull the recoil rope again until the engine starts and allow it to warm up for a few minutes.
- Press the throttle until maximum rpm's are achieved & start cutting.
- For full operating instructions, please refer to the operators manual.

Tool won't start
- Check that the on/off switch is in the on position.
- Make sure that the gas valve lever is in the on position.
- If the tool is flooded, pull the recoil several times while the choke is off & the throttle is in the full position until the engine starts.
- Make sure that the tool has fuel & check the oil level.