- Used to level horizontal areas that are less than 2500 sq. ft.
- Used to cut down on human resources. Jobs for laser applications require one person usage instead of two people..
- Concrete forming, driveways, pools.
- Used to cut down on human resources. Jobs for laser applications require one person usage instead of two people..
- Concrete forming, driveways, pools.
NONE AVAILABLE
- Operating mode: Horizontal.
- Beam Type: Infrared Diode.
- Range: 400ft radius, 800ft diameter.
- Battery life: 55hrs alkaline.
- +/- 3/32" @ 100ft.
- Self leveling system: range to 10 arc min.
- Beam Type: Infrared Diode.
- Range: 400ft radius, 800ft diameter.
- Battery life: 55hrs alkaline.
- +/- 3/32" @ 100ft.
- Self leveling system: range to 10 arc min.
- Set up unit on a domed tripod, you can level it by shifting the unit on the tripod until the bubble is centered in the Cats Eye.
- Use the receiver to spot the beam on a distance rod.
- The receiver will then tell you if you are higher or lower than the first point you measured which is referred to as your benchmark.
- For full operating instructions, please refer to the operators manual.
- Use the receiver to spot the beam on a distance rod.
- The receiver will then tell you if you are higher or lower than the first point you measured which is referred to as your benchmark.
- For full operating instructions, please refer to the operators manual.
Customer comment: The laser does not rotate:
- Check the batteries.
Customer comment: Receiver does not work:
- Check the batteries.
- Perform the self test function by pressing the on/off and illumination button at the same time.
Customer comment: Calibration is off:
- Do a "Peg Board Test" as follows:
1. Set-up and level unit in the middle of large room.
2. Put a distance rod or a tape measure on two opposing walls.
- Check the batteries.
Customer comment: Receiver does not work:
- Check the batteries.
- Perform the self test function by pressing the on/off and illumination button at the same time.
Customer comment: Calibration is off:
- Do a "Peg Board Test" as follows:
1. Set-up and level unit in the middle of large room.
2. Put a distance rod or a tape measure on two opposing walls.
