- Air powered chisel/scalier used to remove ceramic and vinyl tile, and build ups on floors such as rubber, paint or coatings and shingles.
- Scraping up industrial deposits.
- Scraping up industrial deposits.
- Wear safety boots, gloves and hearing protection.
- Weight: 22 lbs.
- Air Requirements: 6-8cfm @ 90 psi.
- Beats per minute: 2500.
- Connect air hose to compressor and to the end of the ALR chisel.
- Make sure the regulator on the compressor is set at NO MORE THAN 90 PSI.
- Failure to do so will blow out the o-rings on the chiseler.
- Also it is worth mentioning that turning up the pressure on the compressor does not increase the speed on the ALR chiseler.
- Place applicable chisel in the collar at the bottom of the ALR chisel.
- Start the compressor.
- Grab the chisel firmly and squeeze the trigger at the end of the ALR to engage.
- For full operating instructions, please refer to the operators manual.
- Make sure the regulator on the compressor is set at NO MORE THAN 90 PSI.
- Failure to do so will blow out the o-rings on the chiseler.
- Also it is worth mentioning that turning up the pressure on the compressor does not increase the speed on the ALR chiseler.
- Place applicable chisel in the collar at the bottom of the ALR chisel.
- Start the compressor.
- Grab the chisel firmly and squeeze the trigger at the end of the ALR to engage.
- For full operating instructions, please refer to the operators manual.
Poor Performance
- Check PSI level coming out of the compressor, DO NOT exceed 8cfm @ 90 PSI.
- Add a few drops of oil into the air fitting located at the top of the unit.
- Check air hose and connections.
- Verify that your compressor is providing the proper air requirements.
- Check PSI level coming out of the compressor, DO NOT exceed 8cfm @ 90 PSI.
- Add a few drops of oil into the air fitting located at the top of the unit.
- Check air hose and connections.
- Verify that your compressor is providing the proper air requirements.
