- Ideal for grinding concrete, terrazzo, brick, stone and is also used for coatings & ceramic tile mortar removal.
- Breaking up manufacturing build ups on floors.
- Texturing surfaces for over lay.
- Creating smooth, level floors.
- Texturing surfaces for over lay.
- Creating smooth, level floors.
- 240v elec. Grinder.
- Do not run more than 75' of 10/3 cord with the unit.
- wear dust masks (unless using with a dust control unit) and safety boots.
- Do not run more than 75' of 10/3 cord with the unit.
- wear dust masks (unless using with a dust control unit) and safety boots.
- Weight: 225 lbs.
- Power: 115/230V single Phase.
- Disc RPM: 400-500.
- Tilt the unit back.
- Take applicable accessory (dyma-serts, scrap-r-tachs or stones) and insert into each of the three designated spots on the two discs with wooden wedges and hammer.
- Be careful as not to smack the actual disc or block with the hammer.
- Tilt unit upright.
- Flip the wheels down, so that the grinder is level.
- There is a vacuum port at the back for dust control.
- On the handle there is a red button, this button stops and starts the unit.
- Also on the unit there is a switch located on the side near the bottom of the handles. This switch must be switched to the applicable setting (240V/110V).
- Work the unit back and forth over the desired area.
- When you are finished and you want to remove the blocks from the discs.
be sure to use the claw on the hammer to push the blocks out.
- DO NOT bang on the blocks to remove.
- For full operating instructions, please refer to the operators manual.
- Take applicable accessory (dyma-serts, scrap-r-tachs or stones) and insert into each of the three designated spots on the two discs with wooden wedges and hammer.
- Be careful as not to smack the actual disc or block with the hammer.
- Tilt unit upright.
- Flip the wheels down, so that the grinder is level.
- There is a vacuum port at the back for dust control.
- On the handle there is a red button, this button stops and starts the unit.
- Also on the unit there is a switch located on the side near the bottom of the handles. This switch must be switched to the applicable setting (240V/110V).
- Work the unit back and forth over the desired area.
- When you are finished and you want to remove the blocks from the discs.
be sure to use the claw on the hammer to push the blocks out.
- DO NOT bang on the blocks to remove.
- For full operating instructions, please refer to the operators manual.
Poor Performance
- Check applicable accessory for proper mounting.
- Verify your using the proper accessory for your application.
- Check the accessory for any damage.
Grinder won't start
- Try the re-set button on the side of the motor.
- Check breaker.
- Check cord for abrasions or cuts.
- Check that cord is hooked up properly.
- Try another outlet as the one your working with may not have enough power available.
- Check applicable accessory for proper mounting.
- Verify your using the proper accessory for your application.
- Check the accessory for any damage.
Grinder won't start
- Try the re-set button on the side of the motor.
- Check breaker.
- Check cord for abrasions or cuts.
- Check that cord is hooked up properly.
- Try another outlet as the one your working with may not have enough power available.
