- Grinding high joints or excess surface material.
- Removing epoxy or urethane coatings.
- Leveling bridge decks or runways.
- Removing epoxy or urethane coatings.
- Leveling bridge decks or runways.
- Wear eye protection, gloves and safety boots.
- Weight: 230 lbs.
- Disc RPM: 2000-2500.
- Power Requirements: 230V single phase.
- Disc Capacity: 10" - 12".
- Tilt the unit back.
- Take the 10" diamond disc and fasten to the bottom of the unit.
- Tilt unit upright.
- Leave the wheels in the forward position (place wheels in back position for very aggressive removal).
- On the handle there is a red button, this button stops and starts the unit.
- Also on the unit there is a switch located on the side of the unit near the bottom of the handles. This switch must be switched to the applicable setting (240V/110V).
- Work the unit back and forth over the desired area.
- For full operating instructions, please refer to the operators manual.
- Take the 10" diamond disc and fasten to the bottom of the unit.
- Tilt unit upright.
- Leave the wheels in the forward position (place wheels in back position for very aggressive removal).
- On the handle there is a red button, this button stops and starts the unit.
- Also on the unit there is a switch located on the side of the unit near the bottom of the handles. This switch must be switched to the applicable setting (240V/110V).
- Work the unit back and forth over the desired area.
- For full operating instructions, please refer to the operators manual.
- Check breaker.
- Check cord for abrasions or cuts.
- Check disc for wear.
- Check cord for abrasions or cuts.
- Check disc for wear.
