- Grinding high joints or excess surface material.
- Removing epoxy or urethane coatings.
- Leveling bridge decks or runways.
- Removing epoxy or urethane coatings.
- Leveling bridge decks or runways.
- Wear eye protection, gloves and safety boots.
- Weight: 230 lbs.
- Disc RPM: 2000-2500.
- Engine: 11hp Honda.
- Disc Capacity: 10" - 12".
- Tilt the unit back.
- Take the 10" diamond disc and fasten to the bottom of the unit.
- Tilt unit upright, try to have the unit tilted as short a period as possible.
- Leave the wheels in the forward position (place wheels in back position for very aggressive removal).
- On the handle there is a red button, this button stops the unit.
- On the other side of the unit is a throttle lever, push this down.
- Pull the recoil rope until the machine starts.
- Work the unit back and forth over the desired area.
- For full operating instructions, please refer to the operators manual.
- Take the 10" diamond disc and fasten to the bottom of the unit.
- Tilt unit upright, try to have the unit tilted as short a period as possible.
- Leave the wheels in the forward position (place wheels in back position for very aggressive removal).
- On the handle there is a red button, this button stops the unit.
- On the other side of the unit is a throttle lever, push this down.
- Pull the recoil rope until the machine starts.
- Work the unit back and forth over the desired area.
- For full operating instructions, please refer to the operators manual.
- Check fuel level.
- Check disc for wear.
- Check disc for wear.
